Need help?Do you have a question about the Litecraft OutLED AT10 and is the answer not in the manual?
General| Category | Flood Light |
|---|---|
| Light Source | LED |
| Color Temperature | 6500K |
| Beam Angle | 120° |
| IP Rating | IP65 |
| Input Voltage | 100-240V AC |
| Frequency | 50/60Hz |
| Material | Aluminum |
Essential safety warnings and instructions for installation, use, and maintenance, including electrical shock and cable handling precautions.
Precautions regarding high temperatures during operation and risks associated with direct exposure to the light source.
Defines the product as a professional spotlight for stages, discotheques, and theaters, approved for outdoor use.
Emphasizes the need for experience in installation, load capacity, and safety inspections.
Warns about potential injuries from falling spotlights and stresses the need for training.
Advises on specified safety distances to flammable materials and proper mounting.
Installation must be approved by an authorized person before initial operation.
Explains the temperature sensor's function to protect internal electronics and LEDs from overheating.
Shows the software version after switching on the unit.
Sets all settings to factory defaults (DMX-4CH, address 001).
Keeps all settings (DMX mode/macro etc.) unchanged; menu disappears automatically.
Displays the fixture's working hours.
LEDs switch off due to excessively high internal temperature.
LEDs reduce driving by approximately 25% due to high internal temperature.
Keeps the display permanently on.
Display switches off after 10 seconds, reactivates with button press.
Sets color macro mode with 43 colors plus black.
Sets color macro mode and dimmer control.
Controls dimmer for red, green, and blue channels.
Controls dimmer for red, green, blue, and amber channels.
Controls color, strobe, speed, and mode functions.
Allows selection of one of 43 pre-programmed colors plus black.
Allows selection of one of 6 pre-programmed chasers.
Sets one of 16 speed values for the chosen program.
Provides 256 DMX steps to set the color red.
Provides 256 DMX steps to set the color green.
Provides 256 DMX steps to set the color blue.
Provides 256 DMX steps to set the color amber.
Details beam spread characteristics for a 25° angle at various distances.
Details beam spread characteristics for a 15° angle at various distances.
Provides key technical details including voltage, power consumption, weight, and IP rating.
To Next Page
