LiteHawk CHARGER 2 - Battery and Charging Procedures; NIMH Battery and Charger Instructions; How to Start

Installation of battery into the boat:
Place your LiteHawk CHARGER 2 on its supplied boat stand to avoid damage to the rudder
and propeller. It is best to always have your boat on the provided stand when not in the
water.
- Remove the hatch on the deck by turning the latch and lifting the cover up from the back.
- Insert the battery on the left or port side of the boat hull. You will see a Velcro strip on
the hull. Match up the Velcro on the battery pack to hold it in place.
- Plug the Red battery plug into the matching plug in the boat. This is a tight fit, but the
plug is keyed so it will only go in one way.
- Reinstall the top hatch.
- Do not store the battery plugged into the boat.
LiteHawk CHARGER 2 Instruction Manual 5
Quick Tip!
LiteHawk replacement batteries and a quick charger will speed up the wait time
between charges! Visit us at www.litehawk.ca
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge
the battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- Do not store the battery plugged into the charger
How to Start!
LiteHawk CHARGER 2 is ready to use - however you must follow these
steps carefully:
1. Switch ON the transmitter.
2. Plug in the battery in the CHARGER 2.
NIMH Battery and Charger Instructions:
Your New LiteHawk comes with a rechargeable NIMH battery. This battery powers the
vehicle.
Please read the following information before using your new LiteHawk.
STEP 1: Remove the wall plug charger from the package and plug it into the wall.
When plugged in a green LED light will come on.
STEP 2: Connect the NIMH battery to the charger. The green LED light will turn to
red.
STEP 3: When the LED indicator light on the charger turns back to green, the battery
is fully charged.
Charge times are (approx. 2 hrs) do not leave on charge overnight. Battery should
be unplugged from the charger after a maximum 3 hours.
STEP 4: Unplug the battery from the charger and remove the charger from the wall
plug.