13
ENGLISH
INSTALLING THE DRIVE
Before you start, please make sure you have installed the proper
software for Recording CDs, DVDs and Playing DVDs. The Recording
software and the DVD Playback software are in different CD kits
included in the package.
1. Start your computer. Wait for the operating system to load, then insert the CD kit.
Follow the instructions on the screen to install the software for Recording CDs,
DVDs or Playing DVDs you wish to install from the CD kit.
2. Connect the power supply to the drive.
(To prevent damage to the power plug, connect carefully to avoid bending the power
plug.)
3. Attach the included Hi-Speed USB cable B type plug to the drive.
(Examine the connection carefully for the correct orientation.)
4. Connect the A type plug end of the Hi-Speed USB cable to the USB 2.0 adapter card
connection on your computer. The drive is ready to use.
(NOTE: If you cannot identify the USB 2.0 connection, refer to the documentation of
your USB 2.0 card. If you do not have a USB 2.0 adapter card installed, you can still
connect the drive to a standard USB 1.1 connection.)
To Next Page
Loading...