To Next PageTo Next Page
Need help?Do you have a question about the Little Cottage Victorian and is the answer not in the manual?
General| Brand | Little Cottage |
|---|---|
| Model | Victorian |
| Category | Play Sets & Playground Equipment |
| Language | English |
Place the floor on the flat surface and install panel A.
Ensure side panels are even and siding is against the floor, then fasten the endwall truss.
Fasten along the bottom edges, making sure the wall is square with the building.
Install panel D and then fasten the 2x3 trusses and gusset.
Place trusses in premarked spots and assemble two pieces to create a T-bar.
Set dormer gingerbread pieces, aligning them with the truss, and place the dormer piece.
Fasten the T-bar on top of the dormer, pushing it in and down against it.
Fasten the T-bar onto the trusses and attach the dormer piece to the gingerbread.
Install four corner gingerbread pieces and the rear truss.
Install OSB sheeting on the rear and front, centering the T-bar before fastening.
Fasten gingerbread trim to the front and install door knob and handles.
Install the heart window, shutters, and flowerboxes.
Install V-channel roof braces and then the drip edge on the roof angles.
Cut and install shingles on the dormer and main roof, including the starter strip.
Install the ridge cap by making center cuts and laying down pieces to fit.
Continue the ridge cap to the edge of the roof and install outside corner trim.
Your playhouse is finished. Enjoy your product.
