Why are my Little Doctor Blood Pressure Monitor measurements too high/low?
If the blood pressure readings from your Little Doctor Blood Pressure Monitor are consistently too high or too low, it could be due to incorrect arm cuff application or movement during measurement. Make sure to apply the arm cuff correctly and remain silent and still during the measurement process.
What to do if my Little Doctor Blood Pressure Monitor doesn't turn on?
If your Little Doctor Blood Pressure Monitor shows no display after pressing the O/I button, the issue might be due to discharged batteries (replace them with new ones), incorrect battery polarity (install them correctly), contaminated battery terminals (clean with a dry cloth), or the power source not being plugged in (plug it into an outlet).
Why is the pulse rate on my Little Doctor Blood Pressure Monitor too high or low?
If the pulse rate measurements on your Little Doctor Blood Pressure Monitor are too high or too low, it might be because you were talking or moving your arm during the measurement. Remain silent and still. Also, avoid taking measurements immediately after physical activity; wait at least 5 minutes before repeating the measurement.
Why does my Little Doctor Blood Pressure Monitor stop and resume inflation?
If the Little Doctor Blood Pressure Monitor stops and resumes inflation, it's likely due to automatic re-inflation to obtain correct measurements. Calm down and repeat the measurement.
Why can't I make many measurements with my Little Doctor Blood Pressure Monitor?
If you can't make a large number of measurements with your Little Doctor Blood Pressure Monitor, the issue might stem from using poor-quality batteries. Use only alkali batteries from well-known manufacturers.
Why does my Little Doctor Blood Pressure Monitor switch to date and time mode by itself?
The Little Doctor Blood Pressure Monitor automatically switches to date and time mode 3 minutes after use. This is normal operation, not a malfunction.
Blood pressure varies due to factors; record readings for doctor's analysis.
Doctor must diagnose and prescribe treatment for hypertension based on readings.
Instructions for inserting 4 "AA" batteries correctly into the compartment.
Recommends using the stabilized power source LD-N057.
Sit comfortably with arm resting at heart level; avoid movement.
Measure lying down with arm at heart level, keeping quiet.
Connect cuff, relax, take deep breaths before measurement.
General| Measurement Method | Oscillometric |
|---|---|
| Display | LCD |
| Memory Function | Yes |
| Irregular Heartbeat Detection | Yes |
| Measurement Location | Upper arm |
| Measurement Accuracy (Pressure) | +/- 3 mmHg |
| Measurement Accuracy (Pulse) | +/- 5 % |
| Automatic Shut-off | Yes |
| Measurement Range (Pulse) | 40-200 beats per minute |
To Next Page
