MIDAS PRO2.
The MIDAS PRO2 has two 4-Pin XLR task light connectors on the back panel. These
connectors are also located just under the top panel overhang that prevents a
standard Littlite XR series gooseneck from snapping in place.
The Littlite LLX XLR connector is designed to enable the pin insert to be rotated to
accommodate different panel socket orientations. (See below for instructions).
The following models Littlites are pre-modified for the PRO2 console.
LED
18XR-4-LED-MR – Right Side Light (Operator’s Right)
18XR-4-LED-ML – Left Side Light (Operator’s Left)
PRO2-LED Set - One MR and One ML.
Halogen
18XR-HI-4-MR – Right Side Light (Operator’s Right)
18XR-HI-4-ML – Left Side Light (Operator’s Left)
PRO2-HI Set - One MR and one ML.
To Next Page