EasyManua.ls Logo

LIVING BASICS LB-IC-16D3 - TROUBLESHOOTING GUIDE

LIVING BASICS LB-IC-16D3
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 5 -
9. Some models have structural design to against cockroaches,if needed,can put something like mothball to
expel the cockroaches.
TROUBLESHOOTING GUIDE
During operations, if any error occurred, please check the following table before
calling for service.
Remedies/controls can not fix the problem,unplug the appliance immediately, contact
PHENOMENON
CHECK POINTS
REMEDY
Get through power supply but no
Bi sound and press the ON/OFF
key
Is the electricity in suspension?
Check whether the electricity
was cut off.
Is the plug connected firmly?
Check whether plug is good
working circumstance.
Check whether fuse is in good
circumstance or not.
Is the fuse broken down?
Induction Cooker send out Bi
Sound
Incompatible cookware or no
cookware is used?
Check the pit using is proper or
not.
Is the cookware not considerable
placed from the center of the heating
zone?
Check whether the pot is sitting
in the center of the plate or not.
Is the cookware bigger than 12cm?
Check whether the diameter of
the pot is bigger than 12cm or
not.
No Operation during the heating
being in use
Is the cookware empty or the
temperature too high?
Please check whether the
appliance is being misused
Is the air intake/exhaust vent clogged
or dirt has accumulated
Remove the stuff clogging the air
intake/exhaust vent. Operate the
appliance again after cooling
down.
Is the cooker working over 2 hours
without any external instruction?
Reset cooking modes or use
timer function
Error codes occur E0
Without Cookware or Incompatible
cookware used
When showing error signal E0,
E3, E5, please check whether the
cookware is not suitable,or
switch on the appliance again
after it is cooled down naturally.
When showing E1, E2, E4, E6, E7,
please contact service center for
checking and repairing
Error Codes occur E1
Low-Voltage
Error Codes occur E2
High-Voltage
Error Codes occur E3
Top plate Overheat
Error Codes occur E4
Top Plate Sensor Open Circuit
Error Codes occur E5
IGBT Overheat
Error Codes occur E6
Top Plate Sensor Short Circuit
Error Codes occur E7
Internal circuit error