What to do if my Living Essentials LINKLIFE Gamma Fitness Treadmill shows Overload Excess of electricity or Protection user exceeded max load weight?
If your Living Essentials Treadmill displays an overload error, ensure the user's weight is within the treadmill's maximum weight capacity. Also, try reconnecting the power and restarting the machine. If the error persists, the control board may need to be replaced.
What to do if my Living Essentials LINKLIFE Gamma Fitness Treadmill shows Motor broken or motor line fall off?
If your Living Essentials Treadmill indicates a motor issue, start by opening the motor cover. Check if the motor is broken or if the motor wire is properly connected to the control board. Reconnect the wire if necessary. If the problem continues, replacing the control board might be required.
What to do if my Living Essentials Treadmill shows Over current Protection Motor Error?
If your Living Essentials Treadmill displays an over current protection motor error, first open the motor cover and check for any blockages. Remove any obstructions you find. If the motor isn't blocked and the error persists, the control board might need replacing.
Why does my Living Essentials LINKLIFE Gamma Fitness have Communication Failures?
Communication failures on your Living Essentials Treadmill can occur if the wires connecting the control board to the panel board are broken or not properly connected. Ensure these wires are securely connected and undamaged. If the error continues, the control board may need to be replaced.
General| Brand | Living Essentials |
|---|---|
| Model | LINKLIFE Gamma Fitness |
| Category | Treadmill |
| Language | English |
To Next Page
