Livox Mid-360 User Manual (English)

Other manuals for Livox Mid-360

Questions and Answers:

Sarah AguilarJul 28, 2025

What to do if Livox Mid-360 Industrial Equipment LiDAR sensor cannot be detected?

E
ericnewtonJul 29, 2025
If the Livox Industrial Equipment LiDAR sensor cannot be detected, ensure all cables are correctly wired. Verify that the power supply voltage is suitable, between 9 V and 27 V. Ensure the LiDAR sensor isn't connected to other software and that both the sensor and host computer are on the same LAN. Check for security software blocking Ethernet broadcasts. If the problem continues, disable firewalls, restart Livox Viewer 2, and try again. Use another application like Wireshark to confirm the packet outputs of all connected devices.

Kathleen Grimes DDSAug 12, 2025

What to do if I cannot connect to the detected Livox Industrial Equipment LiDAR sensor or cannot start sampling?

T
tammykingAug 12, 2025
If you cannot connect to the detected Livox Industrial Equipment LiDAR sensor or start sampling, ensure all cables are correctly wired. Also, make sure the voltage is correct; the working voltage range for Livox Mid-360 is from 9 V to 27 V. If the issue persists, reboot the LiDAR sensor and restart the Livox Viewer 2.

Field of View

360° (Horizontal) x 59° (Vertical)

Protection Rating

IP67

Wavelength

905 nm

Detection Range

40 m @ 10% reflectivity

Laser Class

Class 1

Accuracy

±2 cm

Angular Resolution

0.1° (Horizontal)