Lock'er Down 2011 X User Manual (English)

To Next Page

Instructions for Model 2011 X with USB extension

1. If you have a combination lock, it is easier to set the

combination before installing the safe.

2. Open console and remove rubber pad in the floor of console.

3. There are 4 screws holding down the console, remove all four.

4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.

5. Put in right side plate sliding it under USB cable and attach nuts.

6. put in left side plate and attach nuts.

7. Put in rear piece and put screw in left rear console screw hole.

8. Put in front panel and attach to left front screw hole.

9. Finally place connector strap between front and rear plates and

tighten all fasteners.

Enjoy your purchase.

Each part is described on back.

Installation Video

Need help?

Do you have a question about the Lock'er Down 2011 X and is the answer not in the manual?

Lock'er Down 2011 X Specifications

General

Setting the combination lock before installing the safe is recommended for easier operation.

Remove the rubber pad and all four screws holding down the console for installation access.

Insert the lid assembly as shown in Fig 1, then turn and pull up to the top position.

Install the right and left side plates, sliding them under the USB cable and attaching nuts.

Place the rear piece and front panel, securing them to the console screw holes.

Connect the front and rear plates with the connector strap and tighten all fasteners securely.

The main lid section of the safe, featuring the lock mechanism.

Left and right metal plates that form the sides of the safe unit.

The front and rear metal pieces that enclose the safe.

A connecting strap or bar to secure the front and rear panels together.