Need help?Do you have a question about the LOCK Inspection Sytems LTD MET 30 Plus and is the answer not in the manual?
General| Brand | LOCK Inspection Sytems LTD |
|---|---|
| Model | MET 30 Plus |
| Category | Metal Detector |
| Language | English |
Information regarding health, safety, and compliance with the Health and Safety at Work Act.
Overview of the MET 30+ operating manual contents and section summaries.
Description of the detector's display interface and physical keypad controls.
Steps for performing an initial system check using a provided test sample.
Process for configuring the detector for specific product characteristics and settings.
Details on configuring delay, reject, photocell, and variable speed conveyor timers.
Describes the normal running display, product/reject counts, and initial detection parameters.
Details on system configuration, timer parameters, I/O, system checks, and communication setup.
Explains security codes, operator, supervisor, and engineer menus, and their functions.
Addresses common problems like false triggering, poor sensitivity, and failure to detect test samples.
Lists potential causes for the detector falsely indicating metal presence, including environmental factors.
Details on the sample test operation, reminder facility, and interpreting results.
Actions to take on test failure, including checking setups and engineering configuration.
Covers print modes (event, demand), operator/supervisor menu access for printing, and clearing records.
Details on various report categories (reject, system, sample test, fault), engineering setup for communication and printers.
Wiring diagrams for connecting printers (Epson LX-300, Martel MCP9810) to the MET 30+.
Definitions for fundamental terms like Aperture, Bargraph, Noise, and False Triggering.
Definitions for terms related to product setup, sensitivity, system checks, and test samples.
To Next Page