LOCKEY M210 - User Manual

To Next Page

Digital Door Lock

How to Change the Code

Failure to follow the instructions could

result in damage to your lock, so

please read carefully.

1) Hold the outside body in the horizontal

position. Remove the 2 red screws.

Carefully remove the plate, as there

are many springs attached to it.

2) Important: You must turn the knob

to the clear position and hold in that

position until you have completed

the code change. By not holding

the knob in the clear position, you

could damage the lock and void the

warranty.

3) There are BLUE (non-code) and RED (code) tumblers. Your code is made up of red tumblers

always prefixed by turning knob to clear.

While continuing to hold knob in clear position, use tweezers to lift out code/non-code tumblers

you wish to change.

Turn & Hold

Important:

Hold knob in

clear position,

right or left, while

changing code

Need help?

Do you have a question about the LOCKEY M210 and is the answer not in the manual?

Summary

Remove outer body plate and screws, being careful of attached springs.

Crucial step: hold the knob in the clear position throughout the code change.

Differentiate between blue (non-code) and red (code) tumblers for code setup.

Insert red (code) and blue (non-code) tumblers, ensuring correct orientation.

Replace cover, reinsert screws, and test the new code thoroughly.

General