First install 3 of the 4 batteries. Before installing the
last battery, press and hold the PROGRAM button
while installing the last battery until you hear
a beep from Lockly
®
.
Lockly
®
will then perform a self check and the
keypad screen will start to initiate. This self check
will automatically determine and set your door lock
to a left open or right open door.
+
-
+
-
+
-
+
-
RESET
PROGRAM
After the lock finished the self-check, do the 2-steps below to ensure your lock is properly
installed:
1. Manually lock and unlock your door by
using the thumb turn and the key to
make sure the deadbolt moves smoothly.
If you feel that there is a tight tension
while you are turning, it means that the
lock may have not been installed
straight. Go back to Step 2 and re-install
the lock.
IMPORTANT: If your lock is not properly
installed, it will open and close repeatedly
at times and/or it will reduce battery life.
2. Swipe your hand across the touchscreen
keypad, the lock will close. If the deadbolt
bounces and unlocks automatically, it means
that your lock was installed incorrectly. Go
back Step 2 to make sure your lock was
installed with the (a) deadbolt extended and
(b) the torque blade was inserted vertically
while the deadbolt was extended.
After you checked that the lock manually lock and unlock properly and deadbolt moves
smoothly, install the Battery Cover (H) and secure with screw.
STEP 6. INSTALLING BATTERIES
To Next Page
Loading...
Need help?
General
