Lockly DEADBOLT EDITION 7S - Section 2 - Product Overview; 2.1 Product Overview - Outside

2.1 Deadbolt slit hole must be aligned to the center of the door hole. If not
adjust as shown below:
2.1.1 Wear gloves during adjustment
to prevent pinching your hands
II. Hold the metal plate (c) and
twist the deadbolt body (d)
clockwise till it snaps to 2-3/8"
III. To return to default status,
while the deadbolt (b) is
extended, hold the metal
plate (c) and twist the dead-
bolt body (d) counter-clock-
wise till it snaps to 2-3/4"
(b)
(a)
（c） （d）
（c）
（d）
I. Push the crank (a) to extend
the deadbolt (b)
Deadbolt at 2-3/4" (70mm)
(default shipping status)
STEP 2. ADJUST DEADBOLT AND INSTALL