Set-up solutions
You can arrange your Sound Projector in different set-ups depending on which
other equipment you are connecting to it and the layout of the room. You are
urgently recommended to use the set-up solutions provided and tested by Loewe.
Pay attention to the advice given in the respective enclosed instructions for set-up.
Wall mounting
You can use the wall bracket supplied to mount your Sound Projector on the wall
opposite your listening position.
Mounting on a table
You can use the “Table Stand I Sound Projector“ which can be supplied as an
accessory, to set up your Sound Projector on a flat surface.
Mounting on a floor stand
You can use the “Floor Stand 5 MU“ which can be supplied as an accessory to
set up your Sound Projector on the floor in conjunction with a Loewe TV set.
Please ask your Loewe dealer about other set-up solutions.
Connecting the Sound Projector
You can connect various sound sources to the Loewe Sound Projector.
• Loewe TV-sets from Chassis SL1xx onwards. The device combination Loewe
Sound Projector and Loewe TV set (from Chassis SL 1xx onwards) is par-
ticularly easy to connect and operate (refer to page 13 onwards).
• Loewe TV sets without RJ12/RS-232C system interface (page 15)
• For additional accessories, see page 8.
Setting up
- 12
To Next Page
Loading...
Need help?
General