EasyManua.ls Logo

LOFTNESS 61G4 Series - User Manual

LOFTNESS 61G4 Series
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Model Number:
Serial Number:
Date of Purchase:
Carbide Cutter
61G4 • 71G4
Owner’s Manual and Parts Book
(Originating w/Serial Number
42-1316 thru 42-1665)
N82086 Rev. D 02.13.17

Table of Contents

Questions and Answers

  • A
    Alexis RussellAug 12, 2025
    Why is my LOFTNESS Farm Equipment vibrating excessively?
    • M
      Mary QuinnAug 12, 2025
      Excessive vibration in your LOFTNESS Farm Equipment can stem from several causes. It may be due to broken or missing teeth, which would require you to replace the teeth. Another cause could be mud or debris wrapped around the rotor, in which case you should clean the carbide cutter. Alternatively, a faulty drive line or rotor bearing could be the culprit, necessitating replacement of the bearing(s). If there's damage to the rotor itself, such as a bent end of shafts, missing balance weights, or rotor deformity, consult the factory.
  • J
    Johnny MyersAug 19, 2025
    What to do if the rotor will not turn on my LOFTNESS Farm Equipment?
    • D
      dwuAug 20, 2025
      If the rotor on your LOFTNESS Farm Equipment isn't turning, several issues could be responsible. Check for a faulty drive line or rotor bearing, and replace the bearing(s) if necessary. Inspect the belt for damage and replace it if needed. Also, ensure the belt isn't slipping; if it is, clean or replace it. Finally, you may need to adjust the tension.
  • V
    Veronica JohnsonAug 26, 2025
    How to fix uneven cutting with LOFTNESS Farm Equipment?
    • T
      Tina SchroederAug 26, 2025
      Uneven cutting with your LOFTNESS Farm Equipment can be attributed to a few reasons. The teeth might be dull or excessively worn, indicating they need replacement. Also, the engine RPM might be too slow, so adjust the machine RPM to full throttle. Lastly, the travel speed could be too fast, meaning you should reduce ground speed.
  • B
    Brian BarnettSep 3, 2025
    What to do if there's an oil leak at the hydraulic control valve cover of my LOFTNESS Farm Equipment?
    • K
      Kevin DanielSep 3, 2025
      If you notice an oil leak at the hydraulic control valve cover of your LOFTNESS Farm Equipment, there are a couple of things to inspect. First, check the case drain hose for any pinching. Second, see if the case drain hose is disconnected and, if so, reconnect it.

LOFTNESS 61G4 Series Specifications

General IconGeneral
BrandLOFTNESS
Model61G4 Series
CategoryFarm Equipment
LanguageEnglish