To Next PageTo Next Page
Need help?Do you have a question about the LOGER GG030996 and is the answer not in the manual?
Contains important info for correct assembly and safe use of the appliance. Read all warnings and instructions.
Steps to take if a gas smell is detected, including shutting off gas and evacuating.
Underlining risks of fire, explosion, damage, injury, or death if instructions are not followed.
Ensuring adequate space from buildings, combustible materials, and obstructions.
Prohibits use indoors, in explosive atmospheres, or near flammable materials.
Advice on using protective gear, avoiding loose clothing, and not touching hot surfaces.
Importance of ventilation and advice for use in windy conditions.
Warnings about hot parts, moving the grill, modifications, and cylinder placement.
Specifies LPG gas bottle and regulator compliance with standards.
Advice on proper assembly and caution regarding sharp edges during handling.
Recommendations to reduce gas consumption and cooking time.
Steps for connecting the gas cylinder and regulator, including safety checks.
Crucial warning to always test gas lines for leaks with soapy water after connections.
Key points to read before using the grill, including handling hot parts and gas leaks.
Warning against using the appliance in garages, enclosed areas, or near flammable materials.
Detailed steps for igniting the main burner using the pilot gas control.
Instructions for manual lighting if automatic ignition fails, using a BBQ lighter.
Warnings about outdoor use, keeping combustibles away, and avoiding explosive atmospheres.
Caution to avoid burns by not touching hot parts until cooled, unless wearing protective gear.
Instructions for storing the gas bottle outdoors in a well-ventilated area, disconnected from the grill.
Guidance on cleaning stainless steel surfaces using mild cleaners and appropriate methods.
Procedure for emptying, cleaning, and checking the grease cup to prevent overflow.
Importance of cleaning burner tubes to prevent flashback and ensure proper gas flow.
Conditions that require burner inspection, such as yellow flames or uneven heating.
Detailed steps to remove the main burner from the grill body.
Instructions for correctly seating the valve orifice and reassembling the main burner.
Procedure to remove the side burner from the grill.
Possible causes and solutions for the burner failing to ignite.
Troubleshooting for fires occurring at the control knob area.
Solutions for the flame extinguishing when set to the low setting.
Diagnosing and fixing issues where the burner temperature is insufficient.
General