12
• Alarms: you can set your device to send notifications to you via email or text message at three (3) different situations:
1) If each of measured parameters (like temperature) exceeds or falls from a maximum or minimum defined threshold.
2) If server does not receive any uploads for a certain defined time (in minutes) from your device.
3) If an error code is sent to the device. For example in case of low battery, the device will send error number 5. Please read error” chapter of current user manual to learn more about
meanings of each error code.
• Installation location: It will help you to locate your device if necessary.
• Wi-Fi settings: You can see the name of Wi-Fi that your "bun" is connected to. Also you can set a password for open setup network name “bun hygro” so nobody else can trigger your
device with a magnet and change the setup.
Note: You can always change Wi-Fi settings in your device by triggering “setup” mode as well by hovering a magnet for three (3) or more continuous seconds over magnet
sensor of the device (same as first time activation procedure).
• Reading and uploading intervals.
Note: Your device's battery life will be affected by intervals of readouts and uploads. LoggerMaster web-based application will show you the estimated battery life of the device based
on your settings.
To Next Page
Loading...