Bluetooth Signal Strength to insure that your selected mounting location is
suitable (figure 4). Follow the steps at the top of this screen to perform the signal
strength test. If the measured signal strength is acceptable you will be directed
to make a permanent mount using the provided mounting screws. If the
measured signal strength is too weak at the current temporary mounting location,
you will be directed to perform the test again after moving the LevelMatePRO+ to
another temporary mounting location (figure 5). Tapping on the ‘Troubleshoot
Signal Strength Issues’ link on this screen will give you recommendations for
selecting a more suitable mounting location.
Step 3) Make your selections for Measurement Units, Temperature Units and
the Driving Side Of Road for your country (figure 6). Defaults for these options
are based on the country you defined in the registration process so for most
users these will already be set to the selections you will use.
Step 4) Enter the dimensions for the width and length of your vehicle (figure 7).
Instructions indicating where to take these measurements on your selected
vehicle type are below the front/back and side graphic images of the vehicle.
Step 5) Make your selections for Installation Orientation, Idle Time Until
Sleep, Wake On Motion, Reverse Front View and Measurement Display
Resolution (figure 8). Contextual help is available for some settings and can be
accessed by tapping the icon. Explanations of the other settings are below.
The Installation Orientation setting relates to which way the label faces
after the LevelMatePRO+ has been mounted in its permanent location. See
figure 10 for examples of installation locations and their corresponding
installation orientations.
The Run Continuously setting effectively disables both the ‘Wake on
Motion’ and ‘Idle Time Until Sleep’ settings which will cause the
LevelMatePRO+ to broadcast the Bluetooth signal continuously. While this
setting can be enabled when using the internal battery, it is recommended to
be used only when the unit is externally powered using the micro-USB port.
The Wake On Motion setting, when turned on, will cause the unit to
wake from sleep when motion is detected. Turning this option off will cause
To Next Page
Loading...