TEACH THE EWC TO THE BASE
ON THE CONSOLE: Press and release the
Red Code Learn button, located on the
back near the power cord. You will hear the voice
prompt “Pendant Learning” from the base.
ON THE EWC: Press the Grey
Test Button and the Red HELP
Button at the same time and
hold until you hear “Pendant
Learning” from the EWC.
NOTE: If you are replacing an EWC or pendant, be
sure to erase all pendants rst and then relearn
all present pendants and EWCs to the system. To
erase, simply press the Red Code Learn button for
at least 8 seconds. You will hear the voice prompt
“All Pendants Erased.”
3
MOUNT THE EWC TO THE WALL using
either the screws provided or the double
stick Velcro. If using the screws, place
them exactly 3
1/8th
of an inch apart.
4
NOTE: Be sure to mount EWC low to
the ground and where it can be reached
from both inside and outside of the tub.
CHECK THE SYSTEM. Press the Grey
Test Button for AT LEAST 4 seconds. You
should hear the prompt “All Systems are
OK” followed by the battery
status. If you hear “Base and
Pendant Out of Range,” repeat
Step 2. If still unsuccessful, call
1-800-519-2419.
5
To Previous Page
Loading...