Application Note
ZClone Xi System Restore v1.2h Page 4 of 9
Revised date: 04/30/2021
Logicube, Inc. • 19755 Nordhoff Pl.,Chatsworth, CA 91311 USA• tel:+1-818-700-8488• fax:+1-818-435-0088
www.logicube.com
9. Under ‘Device’, select the drive letter for the USB flash drive that was connected during step 3
then click the Write icon.
10. A confirmation screen will appear. Make sure that the “Target Device” is set to the correct drive
letter. If it is the correct drive letter, click Yes to continue. If it is showing the wrong drive letter,
click No. This will take you back to the previous screen where you can select the correct drive
letter (back to step 9).
11. The USB flash drive is now being prepared and the progress bar should be advancing.
To Next Page
Loading...
Need help?
General