INSTALLATION
14
GB
17. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualied plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water inlet hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from
the water mains needs to be at a minimum
of 0.04 MPa and a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and
then connect the other end of the hose
to your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
Water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
Water supply hose
• Do not bend your drain hose.
You may use a Y-Adaptor (not
included)for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-Adaptor is available
from most DIY stores.
About the Safety Supply Hose
The safety supply hose consists
of the double walls. The
hose’s system guarantees its
intervention by blocking the ow
of water in case of the supply
hose breaking and when the air
space between the supply hose
itself and the outer corrugated
hose is full of water.
LDW60W_T20N_IB_5L_RC_Final210906.indb 14LDW60W_T20N_IB_5L_RC_Final210906.indb 14 6/9/2021 3:04 PM6/9/2021 3:04 PM
To Next Page
Loading...
