EasyManuals Logo

Logik LID45W13N User Manual

Logik LID45W13N
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT
REPAIRS YOURSELF.
Do not sit or stand on the door or dish rack.
Do not move your dishwasher by holding the door or its edges. Hold the
dishwasher around its sides or base when moving it.
Do not touch the heating element during or immediately after use.
Do not operate your dishwasher unless all enclosure panels are properly
in place. Open the door very carefully when there is a programme
running, as there is a risk of hot water spraying out of the appliance.
Do not place any heavy objects on the open door. The appliance could
tip.
When loading items to be washed:
Locate sharp items so that they will not damage the door seal;
Warning: Knives and other utensils with sharp points must be loaded in
the basket with the points downwards or placed horizontally.
Do not allow plastic items to come into contact with heating element.
Check that the detergent receptacle is empty after completion of the
wash cycle.
Do not wash plastic items unless they are marked dishwasher safe or
equivalent.
Use only detergent and rinse aids designed for an automatic dishwasher.
Other means for disconnection from the supply must be incorporated in
the xed wiring with at least 3mm contact separation in all poles.
The door should not be left in the open position since this could present
a tripping hazard.
For energy saving, always remember to switch the dishwasher o when
you have nished using it. The dishwasher should not be left unattended
when in use.
Remove the door to the washing compartment when removing an old
dishwasher from service or discarding it.
During installation, the power supply cord must not be excessively or
dangerously bent or attened.
Do not tamper with controls.
The appliance is to be connected to the water mains using new hose
sets.
The maximum number of place settings to be washed is 9.
The maximum permissible inlet water pressure is 1Mpa, and the
minimum permissible inlet water pressure is 0.04Mpa.
LID45W13N_IB_131028_Zell.indb 7 28/10/13 11:01 AM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik LID45W13N and is the answer not in the manual?

Logik LID45W13N Specifications

General IconGeneral
BrandLogik
ModelLID45W13N
CategoryDishwasher
LanguageEnglish

Related product manuals