7
• For energy saving, always remember to switch the dishwasher off
when you have finished using it. The dishwasher should not be left
unattended when in use.
• If the mains cable is damaged, it must be replaced by the manufacturer
or its service agent in order to avoid a hazard.
• Remove the door to the washing compartment when removing an old
dishwasher from service or discarding it.
• During installation, the mains cable must not be excessively or
dangerously bent or flattened.
• Do not tamper with controls.
• The appliance is to be connected to the water mains using new hose sets.
• The maximum number of place settings to be washed is 10.
• The maximum permissible inlet water pressure is 1Mpa, and the
minimum permissible inlet water pressure is 0.03Mpa.
• Product dimensions - 820 mm - 870 mm (H) x 448 mm (W) x 570 mm (D)
• Aperture dimensions - 820 mm - 870 mm (H) x 450 mm (W) x 620 mm (D)
• For supporting and fixing the appliance see the Installation section.
Earthing Instructions
WARNING: THIS APPLIANCE MUST BE EARTHED.
• This appliance is equipped with a mains cable having an
equipment-earthing conductor and an earthing plug.
• The plug must be plugged into an appropriate mains socket
that is installed and earthed in accordance with local standards
and requirements.
Logik Integrated Diswasher LID45W18 Manual.indd 7 07/12/2018 12:12
To Next Page
Loading...
