26
Operation
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back. It is recommended that the lower basket is loaded rst, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close
rmly afterwards.
4. Press the On/O button, the power indicator light will illuminate.
5. Select the wash cycle programme based on the loading and soil requirements. Please refer to
the “Wash Cycle Table”.
6. The indicator light of the selected programme will illuminate.
7. Close the dishwasher door. A click sound should be heard when the door is closed correctly.
Do not slam the door.
8. The wash cycle will begin shortly.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to check if the detergent dispenser is still closed. This will depend on
how long the washing cycle has been running.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press and hold the Programme button for 3
seconds to cancel the programme. You can then select the new programme and close the
dishwasher door. The unit will start the new wash cycle shortly.
At the End of a Programme
At the end of a programme, the dishwasher will beep.
If you open the dishwasher’s door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after 10 seconds.
The condensation strip helps to prevent the risk of steam damage to the worktop
edging above the dishwasher, it is advisable to leave the door closed until you are ready
to unload the crockery. However, you can also open the dishwasher door fully and wait
until the dishes and crockery are cool enough to unload. Do not leave the door only
partially open.
A forgotten dish can be added if the detergent dispenser is still closed. Carefully open
the door a little to check if the detergent dispenser is still closed. If still closed, wait until
the spray arms stop moving. Open the door wider and add the dish. Close the door. The
machine will restart running shortly. Be very careful of the hot steam and water while
the door is open.
LID60W20_IB_RC_Final210603.indd 26LID60W20_IB_RC_Final210603.indd 26 3/6/2021 5:43 PM3/6/2021 5:43 PM
To Next Page
Loading...
Need help?
General
