You’ll need to first make sure your mouse is compatible with Logitech Flow. You can find the
list of supported devices here.
To set up Logitech Flow:
1. Download and install Logitech Options on the computers you want to use Flow on. You
can get Logitech Options from your product’s Download page.
NOTE: Logitech Options must be installed and Flow enabled on all the computers that
you want to use Flow on.
2. Pair your mouse using Bluetooth or the Unifying receiver to other computers — Logitech
Flow uses Logitech Easy-Switch™ technology to switch between the computers in your
Logitech Flow configuration. See Connect your Logitech Bluetooth device for more
information.
NOTE: You'll need to pair your mouse with the computers that you want to use Flow on
before you can enable Flow.
3. Connect the computers to the same network — make sure all your computers are
connected to the same wireless or wired network. In office environments, where network
ports can be blocked, you might need to talk to your network administrator if Logitech
Flow cannot establish a connection.
To enable Logitech Flow:
When you enable Logitech Flow your computer will find other computers on the network that
are paired to the same mouse. You’ll need to wait for the connection process to take place before
you can start using Flow. If auto-discovery cannot find other computers on your network, make
sure that Logitech Flow is enabled on your other computer(s). You’ll need to have an active
internet connection for the initial connection to be established.
1. Click Enable Flow to initialize the connection between your Flow computers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
