Logitech z333 Complete Setup Guide

English 5
CONNECT TO AUDIO SOURCE
1A. For 3.5 mm connection:
Connect the 3.5mm plug from the subwoofer to the audio jack on your device (computer, tablet, smartphone, etc.)
1B. For RCA connection:
Connect one end of the RCA cable to the corresponding RCA jack on the back of the subwoofer.
Insert the other end of the RCA cable into the RCA outlet on your device (TV, Gaming Console, etc)
Note: The RCA cable is not included in the box and must be purchased separately.
2. Plug your headphones into the headphone jack on the control pod. Adjust the volume either from the control pod orthe
audio source.
3. Power speakers on/o by sliding the power on/o button on the wired control pod.
1A 1B
2 3
3.5mm
ON / OFF
ON / OFF

Logitech z333 Specifications

General

Phase control	Yes
Product color	Black
RMS rated power	40 W
Recommended usage	Universal
Power cable length	1.5 m
Audio output channels	2.1 channels
Satellite speaker type	2-way
Satellite speaker weight	600 g
Number of satellite speakers	2
Satellite speakers RMS power	16 W
Satellite speaker tweeter diameter	3 \
Satellite speaker dimensions (WxDxH)	192 x 157 x 108 mm
Subwoofer sensitivity	96 dB
Subwoofer dimensions (WxDxH)	232 x 157 x 232 mm
Subwoofer driver diameter (imperial)	5.25 \
Power source	AC
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Headphone outputs	1
Amplification device included	No
Amplifier/receiver input interface type	3.5 mm jack
Amplifier/receiver output interface type	RCA
Impedance	10000 Ω