Logtech Marble - AutoScroll Feature Setup; Accessing More Information; Users Guide Location on PC; Users Guide Location on Macintosh

To Next Page

To Previous Page

English

Deutsch Français Italiano Español Português Nederlands Svenska Dansk Norsk Suomi

Ελληνικά

AutoScroll for Your Trackball (Windows

Only)

By using the MouseWare

software, you can set up your trackball to use the AutoScroll feature. AutoScroll allows you

to scroll through large documents in Microsoft

Windows

95, Windows

98, Windows

ME, Windows

2000,

Windows NT

, and in applications that are compatible with Microsoft

Office 97 (or a higher version of

this application) by using a button on your trackball. For more information about AutoScroll, please refer to

the User’s Guide that comes on the Logitech

software CD.

Get More Information!

To help you get the most from your trackball, a User’s Guide is located on the Logitech

software CD.

This User’s Guide contains valuable information about your product, and it has Logitech world-wide addresses

and telephone numbers. During software installation, this User’s Guide is copied to your hard drive automatically.

For PCs

1. From the Windows

Taskbar, select Start, Programs, Logitech

, MouseWare

, then User’s Guide.

2. The User’s Guide displays automatically.

To view a topic, click one of the bookmarks listed on the left side

of the title page.

For Macintosh

1. On your desktop, find the MouseWare

folder, then open the folder by double-clicking it.

2. Find the icon for the User’s Guide, then double-click the icon to open the document.

Troubleshooting

The trackball Does Not Work after Installation or Is Not Detected

• Make sure you have connected the trackball correctly. The trackball cable goes into the computer’s USB port

or PS/2 mouse port.

• For PCs, make sure the PS/2 mouse port has the proper configuration. Refer to your computer documentation

for the correct port configuration. You may also have other system devices that conflict with the trackball.

Check the IRQ/address settings of these devices for conflicts, and change the settings as required.

• Try unplugging then reconnecting the trackball cable to the computer.