Installation Guide (Standard)
Optional OBDii Pass-through Cable Installation Instructions:
1. Unclip or unscrew the vehicle’s stock OBDii plug from its mounting location.
2. Plug the OBDii pass-through cable into the stock OBDii port and clip or screw the opposite end into the
stock plug’s original mounting location using the supplied bracket where necessary.
3. To install the Edge, mount the device as instructed in Step 3 of the standard installation before plugging the
quick disconnect on the device harness into the one on the passthrough cable.
OBDII Pass-through Cable
(where applicable)
Edge M / ATS Harness
To OEM OBD Port
Please contact customer service at: Spireon.com
Phone: 877-563-0032 | Email: LoJackDealer@spireon.com ©2021 Spireon, Inc. All rights reserved.
LoJack Edge M
GPS Device
To Previous Page
Loading...