LOKITHOR J400 - Page 7

2.2 Method 2: Boost Sta
If󶀅J400󶀅cannot󶀅sta󶀅your󶀅vehicle󶀅when󶀅the󶀅batte󶀅of󶀅J400󶀅is󶀅less󶀅than󶀅2󶀅bars,󶀅
please󶀅charge󶀅it󶀅fully󶀅and󶀅t󶀅to󶀅jump󶀅sta󶀅your󶀅vehicle󶀅again.
(Safety reminder: Some safety protection mechanisms are invalid in this mode, so you need to use it with caution.
Be sure to prevent the positive and negative poles from being sho-circuited, otherwise it will cause a
sho-circuit accident. You must check the operating instructions in the manual before operating)
When the automatic sta function fails, you can use the manual emergency sta function after checking the
operating specications in the manual.
2.2.1 Inse the product clamps clip into the EC5 sta po of the product;
2.2.2 Connect the negative electrode of the product clip to the negative electrode of the car batte. 󶀅After waking
the product, press and hold the" " for 5 seconds.Enter the boost sta mode, (in the boost sta mode, the
contact impedance detection can not be used, and the is ashing yellow), at this time, the on the main
inteace is always on, indicating that the product clamp output has been turned on.Connect the positive electrode
of the product clip to the positive electrode of the car batte.
2.2.3 . At this time, the positive and negative voltages of the jump staer and the car are displayed in parallel, and
the car can be staed; sho press the " " or " " to exit.