Need help?Do you have a question about the Lombardini IM Series and is the answer not in the manual?
General| Category | Engine |
|---|---|
| Series | IM |
| Type | Diesel |
| Cooling System | Air / Liquid |
| Starting System | Electric |
| Application | Industrial, Agricultural |
Initial steps for disassembling the engine, including removal of external parts.
Instructions for checking and repairing the cylinder head, including decarbonizing.
Procedures for checking and restoring valve seats, guides, and valves.
Checking piston pin for scoring and measuring clearance in the connecting rod.
Cleaning and checking the crankshaft for cracks, journals, and crankpins.
How to measure cylinder bore diameter and check for wear or scoring.
Measuring piston skirt diameter and checking ring end gap for wear.
Checking wiring, insulation, and alternator output voltage.
Checking connections, regulator ground, and current draw during operation.
Essential checks to perform after engine assembly before initial startup.
Procedure for running the engine at idle speed and checking for smooth operation.
Adjusting idle speed and air-fuel mixture for optimal engine performance.
Adjusting the maximum engine speed and limiting throttle lever travel.
Procedure for breaking in the engine by progressively applying load.
Instructions for heating and installing the crankshaft ball bearing.
Steps for assembling the piston and connecting rod, including ring placement.
Checking ball bearings for play and replacing clutch disc if friction material is worn.
To Next Page