Need help?Do you have a question about the Lombardini LDW 194 JMtI and is the answer not in the manual?
General| Brand | Lombardini |
|---|---|
| Model | LDW 194 JMtI |
| Category | Engine |
| Language | English |
Detailed dimensional drawings for the LDW 194 JMTI engine model.
Detailed dimensional drawings for the LDW 245 JMTI/A engine model.
Labels and diagrams identifying key components on the left side of the engine.
Labels and diagrams identifying key components on the right side of the engine.
Identification of instruments and controls on the De Luxe maxi control panel.
Physical dimensions of the De Luxe maxi control panel.
Identification and illustration of engine vibration mounting components.
Identification and operation of the engine's accelerator lever.
Identification of the reduction reversing gear (Technodrive TM 485 A).
Guidelines and components for installing the raw water cooling system.
Recommendations for installing the engine's exhaust system, including hoses and mufflers.
Components and layout for the engine's diesel fuel system.
Mandatory requirements for engine room extraction and ventilation.
Correct positioning guidelines for the engine's wiring box.
Correct fitting and adjustment procedures for vibration damping mounts.
Specifies the maximum allowable installation and running inclinations for the engine.
Diagrams illustrating the engine's cooling and raw water flow paths.
Diagrams illustrating the engine's fuel system components and flow.
Procedure for filling the engine crankcase with the correct type and amount of oil.
Procedure for checking the engine oil level using the dipstick.
Procedure for filling the reduction-reversing gear with the specified oil.
Procedure for checking the reduction-reversing gear oil level.
Procedure for draining water from the fuel pre-filter.
Procedure for checking and topping up the engine coolant.
Step-by-step guide for starting the engine correctly.
Actions to perform after starting, including checks and engine warm-up.
Understanding different driving positions and basic engine operation.
Recommended steps to perform before shutting down the engine.
Instructions for safely shutting down the engine.
Procedure for draining sea water from the pump after stopping.
Guidelines for the initial engine run-in period and power limits.
Regular checks of sump oil level every 10 hours.
Regular checks of reduction-reversing gear oil level every 10 hours.
Regular checks of coolant level every 10 hours.
Actions for the first 50 working hours, marking the end of the run-in period.
Procedure for replacing engine sump oil every 250 hours or 1 year.
Procedure for replacing the engine oil filter.
Procedure for replacing the diesel fuel filter.
Visual inspection of the seawater pump belt condition.
Procedure for replacing the seawater pump belt.
Procedure for checking the seawater pump impeller for wear.
Procedure for replacing the engine air filter.
Lubrication procedure for the wastegate control lever.
Procedure for checking and replacing zinc anodes for corrosion protection.
Procedure for checking the condition of cooling circuit hoses.
Visual inspection of the alternator belt condition.
Procedure for replacing the reduction-reversing gear oil.
Procedure for replacing the engine coolant.
Cleaning procedure for heat exchanger and intercooler tube bundles.
Procedure for replacing the engine timing belt.
Steps for preparing the engine for storage, including draining and sealing.
Recommendations for storing the engine for periods exceeding six months.
Information on how to contact authorized service centers for assistance and parts.
Details required when ordering spare parts for the engine.
To Next Page