4
Instructions:
BATTERIES AND INSTALLATION
First o, remove the battery door [1] by sliding it out in the direction of the arrow.
Insert one alkaline “AA” battery with the”+” side facing up. Replace the battery
door. Move the Power Switch [2] to “On”. You will hear the ash charge with a
high-pitched whine and the Ready Light [4] will glow. Test the ash by pressing
the Fire Button [3]. To mount the Flash on the Diana F+ camera, simply line up
the twin plugs on the bottom of the ash with the corresponding holes on the
top of the camera. To mount the ash on a standard hotshoe camera (Lomo
LC-A+, Fisheye 2, etc), attach the Plug-to-Hotshoe Adapter [5] onto the bottom
of the ash. Slide the bottom part of this adapter into the camera’s hotshoe as
usual.
To Next Page
Loading...