13
SCANNING PROCESS FOR 35 MM OR 120 NEGATIVES
USING A SMARTPHONE AND THE DIGITALIZA MAX
1. Make sure the Smartphone Stand [C] is attached to the Base Plate [C1].
2. Open the Smartphone Clamp [C6] by turning the Smartphone Clamp Knob
[C8] counterclockwise.
3. Put your smartphone into the Smartphone Clamp [C6] and tighten the
Smartphone Clamp Knob [C8] by turning it clockwise.
4. Make sure your smartphone is secured within the Smartphone Clamp [C6]
and ensure that you don't overtighten the Smartphone Clamp Knob [C8].
5. Put the Backlight Panel with Built-in 120 Film Holder [B] onto the Base
Plate Slider [C2] of the Smartphone Stand Base Plate [C1].
6. If you are scanning 120 film, follow the steps in the previous section to load
your film into the Backlight Panel with Built-in 120 Film Holder [B].
7. If you are scanning 35 mm film, follow the steps in the previous section to
load your film into the 35 mm Film Holder [A]. Put the 35 mm Film Holder
[A] with film loaded on top of the Backlight Panel with Built-in 120 Film
Holder [B].
To Next Page
Loading...