8
MANUAL STEPS
BEFORE USING
Installing batteries into the Backlight Panel with Built-in 120 Film Holder [B]
1. Slide the Battery Door [B5] open.
2. Insert 2 × AA batteries into the Battery Chamber [B6].
3. Close the Battery Door [B5] by sliding it back into place.
Using the Backlight Panel with Built-in 120 Film Holder [B] with a micro-USB
power supply
1. Plug a standard micro-USB cable into the Micro-USB Socket [B4] on the
Backlight Panel with Built-in 120 Film Holder [B].
2. Plug the standard micro-USB cable into a USB power supply (adapter or
power bank).
To Next Page
Loading...