9
MANUAL STEPS - HOW TO USE
LOADING FILM INTO THE 35MM FILM HOLDER [A]
1. Put the 35 mm film tongue into the Film Loading Slot [A2], with the emul-
sion side facing down on the 35 mm Film Holder [A].
2. Hold the 35 mm film and turn the Film Loading Knob [A1] clockwise, the
film will then be loaded into the 35 mm Film Holder [A] and will come out
via the Film Ejection Slot [A3].
3. Turn the Film Loading Knob [A1] back and forth to adjust the frame position
of the film inside the 35 mm Film Holder [A].
4. You may insert the 36 × 24 mm Film Mask [B8] on top of the Backlight
Panel [B3] to cover any unwanted areas or perforations of the 35 mm film
if needed, and achieve a faster scanning process for each standard 35 mm
frame.
5. If you are scanning panoramic frames, such as photos taken with a Sprocket
Rocket camera, endless panoramas or overlapping exposures; you should insert
the 35 mm Panoramic Diffuser [B9] on top of the Backlight Panel [B3]
to ensure that the frame is evenly lit. When not in use, remove the 35 mm
Panoramic Diffuser [B9] by opening the 120 Film Holder Cover [B1]
To Next Page
Loading...