To change the batteries of the Remote Control Lens Cap, simply open the Battery
Door rc4 at the bottom of the Remote Control Lens Cap by sliding it. Then install
one CR1632 battery (3 V) and close the Battery Door rc4.
TROUBLESHOOTING
q The camera is functioning but the film does not eject after the Shutter
Release Button / Self–Portrait Mirror 7 is pressed.
a Please check the following:
e Make sure that the camera is turned on and focus is set to either 0.6 m,
/ 1–2 m / infinite.
e Make sure there is film installed in the camera.
e Check the Film Counter Indication LED 3, if the lights are blinking quickly
then your film has come to an end and needs to be replaced.
e Check whether the MX Mode Indication Light 17 above the MX Button 16
is on. If it is, that means you are in the MX Mode. Press the MX Button 16
again to switch off the MX Mode.
e Look at the Shooting Mode Indication Light 18 to check the battery
power, if it’s blinking, it’s time to change the batteries.
q The automatic exposure seems to be incorrect, my subject is under– or
overexposed.
ENGLISH / 17
To Next Page
Loading...
