Diesel Generator Operating Instructions
Description of Spare Parts
1514
AC circuit
breaker
Output
indicator
GeneratorDiesel Operating Instructions
Description of Spare Parts
Fuel tank
Fuel tank
cap
Fuel
gauge
AC output
It is used to hold fuel diesel fuel is allowed only,.
Screw the fuel injection port in use and do not open it in
equipment operation.
It is to indicate fuel level in the fuel tank.
AC output socket provides the power supply Pls refer to
model s parameter table for its rated power load of each
socket cannot exceed its rated current and total power of
electric device cannot surpass rated power of the generator
Do not start up several electric devices simultaneously but
switch on another one after stable operation of one electric
device
.,
'.
,
.
,
.
It will break to protect the electric device when current is
too heavy.
It is to indicate power supply status The indicate will
brighten up when the equipment operation
.
.
Engine
switch
It is to start up and switch off the engine Turn to the off state
in nonuse
.
. It is used when the engine is difficult to start in cold
weather For the method refer to the Page 18., .
Wheel
(optional)
It is for moving the generator in a short time.
Battery
It is for starting up the generator In case of nonuse for
three months charge it
,
,.
Handrail
pipe
Oil drain
bolt
Foot
It is for measurement of engine s oil level Make sure
engine s oil level is between MIN and MAX in the dipstick of
oil filler cap before use Oil can be added after removing the
oil filler cap
'.
'
.
.
Unscrew this bolt when replacing the engine oil Drain out
the old engine oil and dispose of it properly according to
local laws aoviding damage to the environment
.
,.
It is to support the generator.
It is to make the generator realize safe grounding As to the
grounding method refer to the Make sure
unobstructed grounding before use
.
,
.
Page15.
After lifted up the pipe with self locking structure can be
used to move the generator
,,- ,
.
It is to start up the engine.
It is to filter air and remove impurities in the air entering
cylinder As to the maintenance method refer to Page 26.,.
It is to control the engine speed.
It is to eliminate noise during equipment operation and
discharge high temperature exhaust of engine s combustion
Do not touch it to avoid scalding
,
'.
.
Dipstick
Grounding
terminal
Air
cleaner
Speed
controler
Muffler
Start motor
To Next Page
Loading...
Need help?
General
