24
Accessories Installation
You can install the wheel assemblies for the convenience of moving
the unit
You may need to prepare the following equipment before the installation.
.
,Please install the handrail vibration reduction bracket and wheel on the
base plate and tighten the bolt as shown in the following picture.
Two-wheel short axle
Vibration reduction bracket
Vibration reduction rubber pad
Handrail
Axle
Wheel
Cotter pin
Washer
Diesel Generator Operating Instructions
Accessories Installation
25
Transporting
To prevent fuel spillage when transporting or during temporary storage,
the generator should be secured upright in its normal operating
position,with the engine switch OFF.
The fuel valve lever should be turned OFF.
When
Do not overfill the tank.
Do not operate the generator while it is on a vehicle.Take the
generator off the vehicle and use it in a well ventilated place.
Do not drive on a rough road for an extended period with the
generator on board.If you must
transporting the generator:
transport the generator on a rough
road,drain the fuel from the generator beforehand.
NOTE:
To
Take care not to drop or strike the generator when
transport the generator,hold the holding part(shaded areas in the
figure 1).
transporting.
Do not place heavy objects on the generator.
When transporting the generator by loading it on to a vehicle,secure to
the generator frame as shown(See figure 2).
HOLDING PART
Figure 1 Figure 2
!
WARNING
GeneratorDiesel Operating Instructions
Transporting
To Next Page
Loading...
Need help?
General
