10
2) Generator Ground System
To prevent electrical shock from faulty appliances, the generator should be grounded.
Connect a length of heavy wire between the ground terminal and the ground source.
The generators have a system ground that connects generator frame components to
the ground terminals in the AC output receptacles. The system ground is not connected
to the AC neutral wire. If the generator is tested by a receptacle tester, it will not show
the same ground circuit condition as for a home receptacle.
Special Requirements
There may be Federal or State Occupational Safety and Health Administration (OSHA)
regulations, local codes, or ordinances that apply to the intended use of the generator.
Please consult a qualified electrician, electrical inspector, or the local agency having
jurisdiction.
· In some areas, generators are required to be registered with local utility companies.
· If the generator is used at a construction site, there may be additional regulations
which must be observed.
3) AC Applications
Before connecting an appliance or power cord to the generator:
· Make sure that it is in good working order. Faulty appliances or power cords can
create a potential for electrical shock.
· If an appliance begins to operate abnormally, becomes sluggish or stops suddenly,
turn it off immediately. Disconnect the appliance, and determine whether the
problem is the appliance, or if the rated load capacity of the generator has been
exceeded.
· Make sure that the electrical rating of the tool or appliance does not exceed that of
the generator. Never exceed the maximum power rating of the generator. Power
levels between rated and maximum may be used for no more than 30 minutes.
Ground
terminal
To Next Page
Loading...
Need help?
General
