commended type.
right gap (0.6-0.8mm) between the elec-
socket wrench.
Install the spark plug and tighten with a
Using a thickness gauge, check for the
Clean the electrodes with a metal brush
socket wrench.
Remove the spark plug using a spark plug
in its housing and refit the cover.
Remove the rag, install the filtering element
inlet duct with a rag to prevent them from
Clean the inside of the filter housing from
NEVER be oiled.
The sponge pre-filter must
f)
e)
Do not use water, petrol,
detergents or any other products to clean the
cartridge.
dust and debris, making sure to block the
entering the engine.
SPARK PLUG SERVICE
a)
b)
and remove any carbonaceous build-up.
c)
trodes.
d)
Replace the spark plug if the electrodes are
burnt or if the porcelain is broken or damaged.
Fire hazard! Do not check
the ignition system with spark plug remov-
ed.
Use only spark plugs of the
re
TUNING THE THROTTLE CABLE AND
THE CARBURETTOR
Should the engine not reach maximum revs with
the throttle trigger set to “FAST”, it could be due
to the throttle trigger and speed control lever
being out of phase or to a carburetion problem.
Go to a specialised Centre or contact your
Dealer to restore normal operation.
6.7
IMPORTANT
!
WARNING!
6.6
IMPORTANT
IMPORTANT
7
EN
To Next Page
Loading...
Need help?
General
