EasyManua.ls Logo

LONCIN LC2V80FD - Wiring Diagram; Powered Starting System with Oil Protection

LONCIN LC2V80FD
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery
- 27 -
10. Batteryoptional
Please choose the battery, 12V, rated capacity of 36Ah. or more
Never connect the positive and
negative electrodes in reverse, otherwise, it will
damage the engine and battery severely.
Check the electrolyte level in cell if they are in the
position between the top limit line and low limit
line. If the electrolyte level is lower the low limit
line, screw out the cap and fill distilled water till it
rises up to top limit line. All electrolyte level in
cells should be almost in the same height.
· If operate improperly, the battery may explodethus, hurt may occur to the persons
around, therefore, keep the smoke and flame and inflammable things away from the
battery.
· the battery will release explosion gas, keep the fire away from it. When charge the
battery or use the battery, keep ventilating.
Connect start motor
Be careful not to connect the terminals in reverse, or short circuit occurs. As usual,
connect the positive electrode before do it for negative one.
1) Connect positive wire of the battery to the terminal of start relay.
2) Connect negative wire of the battery to the screw of engine bracket.
3) Connect positive wire of the battery to the positive terminal of the battery.
4) Connect negative wire of the battery to the negative terminal of the battery..
Upper line
Lower line
Caution
Warning
Negative wire
Start delay
Positive wire

Other manuals for LONCIN LC2V80FD

Related product manuals