EasyManua.ls Logo

Lonking CDM308 - Page 68

Default Icon
81 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER IV MAINTENANCE SECTION
62
4.4.1.7 Regular maintenance should be done in daily , 50,100, 250, 500, 1000, 2000 hours.
TABLE 9
cycle Inspect content
Daily
1
Inspect the level of the cooling water and the anti-freezing fluid
2
Inspect oil sump of the diesel, engine oil surface of the speed
regulator(injection pump)
3
Inspect whether the leather belt is loose or not.
4
Inspect the starting possibility, colour of the exhaust and abnormal
noise.
5
Inspect the braking capacity.
6
Inspect the flexibility of the direction.
7
Inspect the leakage of the oil and water in every system.
8
Inspect and monitor the working condition of the instrument.
9
Inspect the whether there is abnormal noise and overheating or not.
10
Inspect the air pressure, cracking or not, or abnormal wear
11
Inspect the working condition of the switch, the pedal, the handle and
the button.
12
Inspect whether bolts and nuts in every part are loose, fallen off or
not.
13
Inspect whether the wheel nuts, hub assembly bolts are loose or not.
14
Inspect the flexibility of control lever system, fill the lubricating grease.
15
Fill the lubricating grease to every articulating point and pin shaft
sleeve.
16
Inspect the safety belt.
17
Inspect the separator for the water and sediments.
EVERY 50 HOURS
Besides the daily life maintenance of the machine, follow work needs to
do.
1
Clean the filter of the diesel engine, replace the diesel oil paper filter
core.
2
Clean the air filter core, replace it if necessary.
3
Inspect whether the binding bolt of engine support is loose or not.
4
Inspect the working device, frame and cosmetic parts.
5
Inspect the level of the hydraulic oil , fill it if necessary.
6
Clean the contaminant on the surface of the radiator and cooler.
EVERY 100 HOURS
Besides the 50 hours maintenance for the machine, follow work needs to
do.
1
Replace the diesel engine oil, engine oil filter (replace at the first time).
2
Clean the terminal end of the battery.
3
Inspect the piston rod of the oil cylinder.
EVERY 250 HOURS
Besides the 100 hours maintenance for the machine, follow work needs to
do.
1
Replace the anti-freezing fluid.
2
Replace the diesel engine oil, engine oil filter.
3
Inspect the tension of the chain, tight the chain if necessary.

Related product manuals