FR
Your 765 Optimum is tted with two bottle mounts,
one on the seat tube and one on the down tube.
Remove the four M5 screws using a 4mm Allen key.
Install the bottle holders (please see the relevant
product manual), then grease and tighten the
screws to a torque of 3Nm.
Your bottom bracket is based on the T47 M47
standard, which is 85.5mm wide.
Always follow the manufacturer’s assembly
instructions.
Our fork legs feature the standard LOOK conical-
head thru axle to eliminate any axial and radial play
(tightening torque 11Nm).
The 765 is designed to accommodate tire widths up
to 700x34C.
BOTTOM BRACKET
WHEEL ASSEMBLY
HYDRATATION
IMPORTANT : We strongly advise you to contact
your nearest LOOK retailer for more information
on compatible bottom brackets.
Warning : Use only the original screws
provided.
!
Fig.22
It is important to regularly check and service your
bicycle to ensure your safety and optimize the
lifespan of your product. A poorly maintained bicycle
or components may break or fail and potentially
cause an accident, serious injury or paralysis.
MAINTENANCE
For more information on maintenance
requirements, please refer to our website
www.lookcycle.com, WARRANTY POLICY >
IMPORTANT INFORMATION.
21
To Next Page
Loading...
