Loop Telecom Loop-O9500R - Page 22

Loop-O9500 SDH/SONET IMAP
SDH/SONET-MSTP
22
TDMoE
Combo Gigabit Ethernet(GbE) Interface
Number of Ports
2
Speed
10/100/1000M bps
Connector
RJ45 for twisted pair GbE, LC for optical GbE, auto detection
Gigabit Ethernet(GbE) Interface
Number of Port
2
Speed
10/100/1000 BaseT
Connector
RJ45
Ethernet Function
Basic Features
MDI/MDIX for 10/100/1000M BaseT auto-sensing
Ping function contained ARP
Per port, programmable MAC hardware address learn limiting (max. MAC table 8192 (8k) entry)
Packet Delay Variation:
- Unframed T1: Up to 340 ms
- Framed T1: Up to 256 ms
- E1:up to 256 ms
- Framed T1 with CAS: Up to 192 ms
Packet Transparency
Packet transparency support for all types of packet types including IEEE 802.1q VLAN and 802.1ad
(Q-in-Q)
QoS
User configurable 802.1p CoS, ToS in out going IP frame
Traffic Control
Ingress packet Rate limiting buckets per port for ethernet port
Supporting Rate-based and Priority-based rate limiting for LAN port
Granularity:
a. From 64 Kbps to 1 Mbps in increments of 64 Kbps
b. From 1 Mbps to 100 Mbps in increments of 1 Mbps
c. From 100 Mbps to 1000 Mbps in increments of 10Mbps
Pause frame issued when the traffic exceeding the limited rate before packet dropped following
IEEE802.3X
Link Aggregation
WAN support link aggregation
Jitter & Wander
PPM: per G.823 Traffic
Standard Compliance
IETF
TDMoIP (RFC5087), SAToP (RFC4553), CESoPSN (RFC5086)
IEEE
802.1q, 802.1p, 802.1d, 802.3, 802.3u, 802.3x, 802.3z, 802.1s, 802.1w, 802.1AX