program to be effective.
A Lit - shows that the program has been set.
A Red - means that the program is in effect.
To check a program that’s been set, repeat the steps above to show the Flashing
- and it will show you the time that has been programmed.
To cancel a program, cycle through the functions by pressing the POWER to
turn off, turn on again if needed.
POWER/MODE Function Map
function will cycle through the list accordingly.
F
Power
Off
Fan
HI
LO
AUTO
Mode
Mode
Time Set
Time Set
Temp Setting
Time On(1)
Time On(1)
Time Off(1)
Time Off(1)
Time On(2)
Time On(2)
Time Off(2)
Time Off(2)
By Pressing POWER/MODE the
unction of Oscillation.
When the machine is on and under operation, the oscillating motor runs by pressing
OSCILLATION key.
RESET INSTRUCTIONS
z This heater is equipped with an overheating cut-off switch which will shut the unit
S g, please follow these steps before
0 MINUTES
off if the internal heating components overheat.
hould the heater shutdown due to overheatin
reusing heater:
1) TURN MODE TO OFF
2) UNPLUG UNIT WAIT 1
3) PLUG IN AND TURN ON
6
To Next Page
Loading...
Need help?
Power