Why is the torque indication wrong on my LORENZ MESSTECHNIK Accessories?
If you observe a wrong torque indication with your LORENZ MESSTECHNIK Accessories, it might be due to several reasons. The calibration could be incorrect, requiring you to re-calibrate the device. Alternatively, there might be a torque shunt that needs to be eliminated. In some cases, the sensor itself could be defective, necessitating repair by the manufacturer.
What to do if the LORENZ MESSTECHNIK DR-2112 Accessories sensor does not react to torque?
If your LORENZ MESSTECHNIK Accessories sensor isn't reacting to torque, several factors could be at play. Ensure the shaft is correctly clamped. Check the power supply to confirm it's within the permissible range and properly connected, without any cable defects or mains supply issues. Also, verify that the connector is correctly connected. A cable defect can also cause this issue, so inspect and repair the cable if needed.
Why is the zero point outside of tolerance on my LORENZ MESSTECHNIK DR-2112 Accessories?
If the zero point is outside of tolerance for your LORENZ MESSTECHNIK Accessories, several factors could be responsible. A cable defect might be the cause, so try repairing the cable. Ensure that the shaft is mounted correctly and not distorted. Check for a distorted shaft string and release it from distortion if present. Reduce any strong lateral forces acting on the device. Inspect the flanges for evenness of their surfaces. If the shaft is overloaded, it may need to be sent to the manufacturer.
What causes signal dropouts in LORENZ MESSTECHNIK DR-2112 Accessories?
If you are experiencing signal dropouts with your LORENZ MESSTECHNIK Accessories, it could be due to the axial position of the rotor relative to the stator being outside of tolerance; in this case, you should align the rotor. Another potential cause is a cable defect, which would require you to repair the cable.
How to troubleshoot no signal from LORENZ MESSTECHNIK DR-2112?
If you're not getting a signal from your LORENZ MESSTECHNIK Accessories, it could be due to a few reasons. There might be no sensor excitation because it's outside the permissible range, so connect the excitation properly. Check for cable defects or a lack of mains supply. Another possibility is that the signal output is connected incorrectly, so ensure it's properly connected. If these steps don't resolve the issue, the evaluation electronics might be defective.
What causes oscillations in LORENZ MESSTECHNIK Accessories?
If you're experiencing oscillations with your LORENZ MESSTECHNIK Accessories, it might be due to incorrect alignment of the shaft; ensure it is correctly aligned. Another possible cause is unbalance, so balance the corresponding parts.
General| Brand | LORENZ MESSTECHNIK |
|---|---|
| Model | DR-2112 |
| Category | Accessories |
| Language | English |
To Next Page