Lorex sweet peek User Manual (English)

Questions and Answers:

R
Richard ComptonJul 26, 2025
What to do if my Lorex sweet peek Baby Monitor camera is not detected?
- L
  Lauren WoodJul 26, 2025
  If your Lorex Baby Monitor camera is not detected and shows “Out of Range”, try these steps: 1. Select the correct channel by pressing the channel button repeatedly. 2. Ensure the camera is powered on. 3. Replace the camera batteries if they are low. 4. Extend the antennas on both the monitor and camera, or move them closer together to improve the signal. 5. You may need to pair the camera and the monitor again.
D
david20Aug 2, 2025
How to fix no video on my Lorex sweet peek Baby Monitor?
- A
  amandakellyAug 2, 2025
  If no video is displayed on your Lorex Baby Monitor, try the following: * Press and hold the power button to ensure the monitor is on. * Plug in the monitor power adapter, as the monitor may be out of batteries. * Press any button to turn the screen back on, as Video Off or VOX mode might be enabled.
K
Kevin LongAug 9, 2025
Why does my Lorex sweet peek Baby Monitor screen keep turning off?
- J
  Jessica ClaytonAug 10, 2025
  Your Lorex Baby Monitor screen might be turning off due to the following reasons: * VOX mode is enabled. For details on disabling VOX mode, see “Enabling VOX Mode (Voice Trigger)” on page 14. * The monitor battery is low. Try plugging in the monitor power adapter.
N
nicolekruegerAug 17, 2025
How to stop feedback noise on Lorex sweet peek Baby Monitor?
- M
  Matthew MendozaAug 17, 2025
  If you are experiencing feedback or squealing noise from your Lorex Baby Monitor, here are a few things you can try: * Move the camera and monitor further apart from each other. * Lower the monitor volume. * Avoid placing the monitor and camera near televisions, computers, cordless/mobile phones, or other electrical equipment to ensure optimal performance.

Lorex sweet peek Specifications

General

Modulation	GFSK
Certification	FCC 15C 247
Maximum range	- m
Channels quantity	19 channels
Smartphone support	-
Transmitting power	18 dBmW
Number of lullabies	5
Maximum indoor range	46 m
Maximum outdoor range	138 m
Speaker type	2-way
Product color	White
Card reader integrated	No
LED type	IR
Sensor type	CMOS
Fixed aperture	2.8 mm
Video resolutions	640 x 480 pixels
Fixed focal length	3.6 mm
Optical sensor size	1/5 \
Minimum illumination	0 lx
Number of illumination LEDs	6
Interface	FHSS
Frequency band	2.4 GHz
Maximum number of cameras supported	4
DC input voltage	6 V
Power source type	Battery, DC
Battery life (max)	8 h
Display diagonal	2.4 \
Display resolution	320 x 240 pixels
Viewing angle, horizontal	90 °
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (receiver)	20 - 85 %
Package depth	97 mm
Package width	229 mm
Package height	158 mm
Package weight	650 g