FCC
Statement
Please take attention
that
changes
or
modification
not
expressly approved by the
party responsible
for
compliance could void
the
user's authority
to
operate
the
equipment.
This device complies
with
Part 15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
1. This device may
not
cause harmful interference, and
2. This device must accept any interference received, including interference
that
may cause undesired operation.
Ca
ution: The user
that
changes
or
modifications
not
expressly approved by the
party responsible
for
compliance could void the user's authority
to
operate the
equipment.
This equipment has been tested and found
to
comply
with
the
limits
for
a
Class
B
digital device, pursuant
to
Part 15
of
the
FCC
Rules.
These limits are designed
to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates,
uses
and
can
radiate radio frequency energy
and,
if
not
installed and used in accordance
with
the instructions, may cause harmful
interference
to
radio communications. However, there
is
no guarantee
that
interference will
not
occur in a particular installation.
If
this equipment does
cause
harmful interference
to
radio
or
television reception, which
can
be determined
by turning the equipment
off
and on, the user is encouraged
to
try
to
correct the
interference by one
or
more
of
the following measures:
• Reorient
or
relocate
the
receiving antenna.
• Increase
the
separation between
the
equipment and receiver.
• Connect
the
equipment
into
an
outlet
on a circuit different from
that
to
which the receiver
is
connected.
• Consult
the
dealer
or
an
experienced radio/TV technician
for
help.
RF
exposure warning
This equipment must be installed and operated in accordance
with
provided
instructions and antenna(s) used
for
this transmitter must be installed
to
provide a
separation distance
of
at
least 20cm from all persons and must
not
be co-located
or
operating in conjunction
with
any
other
antenna
or
transmitter. End-users and
installers must be provided
with
antenna installation instructions and transmitter
operating conditions
for
satisfying
RF
exposure compliance.
The equipment should be installed and operated
with
a minimum distance 20cm
between
the
radiator and
your
body.
For full
FCC
compliance declarations, visit
https://www.lorex.com/pages/fcc-compliance
Declaration
of
Conformity
UKCA
UK
CA
This device complies
with
UKCA
relevant directives and standards.
UK
Declaration
of
Conformity (Doe)
can
be downloaded from:
https://www.lorex.com/pages/ukca-compliance
lorex
Technology
UK
limited
1 Georges Square, Bath Street, Bristol, United Kingdom, 851 68A.
lo
T_FCC_IC_UKCA..R3
To Previous Page
Loading...
Need help?
General
