RESIZING/CHANGING THE BRACELET
MICROADJUSTMENT
Use the round end of
the strap changing tool
to push in the clasp
springbar, then move
the springbar into the
desired slot.
Make sure it is in the
same slot on both sides
of the clasp.
SIZING WITH LINKS
Use the screwdriver to
remove and replace links as
needed.
For a secure fit, we highly
recommend applying
low-strength threadlocker,
such as Loctite 222/222MS
(not included).
CHANGING STRAPS
Use the strap changing tool
to remove and replace the
springbar.
One side at a time, insert the
round end into the lug holes
and gently pull the bracelet
so that both ends are out.
Place the springbar back
into the holes for use with
another strap.
PLEASE USE CAUTION
WHEN REMOVING THE
SPRINGBAR AS IT COULD
FLY OUT
To Next Page
Loading...